SKETCHMODE

Determines selection and editing features that are used for basic sketching. The value is a bit code and can be the sum of any of the following values:

0 = Off.

1 = Boundaries (closed entities) can be selected by clicking inside the boundary rather than at the edge of the boundary. Supported entities include arcs, circles, ellipses, splines, and polylines (2D and 3D).

2 = Selection grips display for an entire selection set and allow you to quickly move, scale, and rotate all selected entities. These types of grips can be helpful for schematic drawings where precise scale or sizing is not required.

Type:     Integer

Saved:     In the registry

Range:     0 to 3

Default:     0