Dome (3D Mesh)
()
Keyboard: AI_DOME, and DOME for versions without support for ACIS solids
IntermediateDraws the upper half of a sphere as a 3D mesh. The flat side of the sphere faces down.
To draw a dome based on the radius
- Specify the radius of the dome.
Center of dome: Specify the center point of the dome.
Diameter � <Radius of dome>: To draw a dome based on the radius, enter the radius or specify a point. To draw a dome based on the diameter, choose Diameter and enter the diameter, or specify a point.
Number of divisions around dome <16>: Specify the number of horizontal divisions around the dome, usually between 4 and 20. A large number of divisions takes the program longer to display the dome. A small number of divisions makes the dome unrecognizable.
Number of top-to-bottom divisions <8>: Specify the number of vertical divisions up and down the dome.
To draw a dome based on the diameter
- Specify the diameter of the dome.
Center of dome: Specify the center point of the dome.
Diameter � <Radius of dome>: Choose Diameter.
Diameter of dome: Enter the diameter of the dome, or specify a second point.
Number of divisions around dome <16>: Specify the number of horizontal divisions around the dome, usually between 4 and 20. A large number of divisions takes the program longer to display the dome. A small number of divisions makes the dome unrecognizable.
Number of top-to-bottom divisions <8>: Specify the number of vertical divisions up and down the dome.