Dish (3D Mesh)
()
Keyboard: AI_DISH, and DISH for versions without support for ACIS solids
IntermediateDraws the lower half of a sphere as a 3D mesh. The flat side of the sphere faces up.
To draw a dish based on the radius
- Specify the radius of the dish.
Center of dish: Specify the center point of the dish.
Diameter � <Radius of dish>: Enter the radius or specify a point.
Number of divisions around dish <16>: Specify the number of horizontal divisions around the dish, usually between 4 and 20. A large number of divisions takes the program longer to display the dish. A small number of divisions makes the dish unrecognizable.
Number of top-to-bottom divisions <8>: Specify the number of vertical divisions up and down the dish.
To draw a dish based on the diameter
- Specify the diameter of the dish.
Center of dish: Specify the center point of the dish.
Diameter � <Radius of dish>: Choose Diameter.
Diameter of dish: Enter the diameter of the dish, or specify a second point.
Number of divisions around dish <16>: Specify the number of horizontal divisions around the dish, usually between 4 and 20. A large number of divisions takes the program longer to display the dish. A small number of divisions makes the dish unrecognizable.
Number of top-to-bottom divisions <8>: Specify the number of vertical divisions up and down the dish.
Tell me about...
How do I...