progeCAD Professional manual The low-cost alternative to AutoCAD

Index



Do you want to try progeCAD Professional?
Download the trial: you can try the product, without any limit, for 30 days!

A manual page a day... Click here to see the manual table of contents.

Getting drawing information

Specifying measurements and divisions

You can divide a line, arc, circle, or polyline into a number of equal segments or mark off intervals of a specific length along an entity. (Note that divide is not the same as break.) For example, you may want to place station-point markers every 50 feet along the centerline of a roadway or divide the plan view of a window into three equal-width sections of glass, placing a mullion at each division point.

To specify measurements and divisions, use these commands:

For the length of the segments, use the Measure command.

For the number of equal-length segments, use the Divide command.
  1. You can measure or divide arcs, circles, lines, and polylines. With either command, you can identify the segments by placing either a block or point entity at the end of each interval. If you use points, you can snap to the ends of intervals using the point entity snap. The appearance of the point entities is determined by the current point display type, which you control in the Drawing Settings dialog box.
  2. To use a block as the marker, the block must already be defined in the current drawing. You can further indicate whether to rotate the block to align perpendicularly to the entity you are measuring or dividing.
  3.  

     

     

    Block not aligned with entity.

     

    Block aligned with entity.

  4. progeCAD begins measuring or dividing based on the point at which you select the entity and the type of entity with which you are working. For most entities, measuring starts from the endpoint closest to the point you used to select the entity. If you select the entity to be measured or divided using a method other than pointing (for example, using a window or fence selection), the program prompts you to specify the end from which you want to begin measuring.