progeCAD Professional manual The low-cost alternative to AutoCAD

Index



Do you want to try progeCAD Professional?
Download the trial: you can try the product, without any limit, for 30 days!

A manual page a day... Click here to see the manual table of contents.

Getting drawing information - Specifying measurements and divisions - Specify the segment length, and then press Enter.

Dividing entities into segments

You can place markers along a selected entity, dividing that entity into a specified number of equal-length segments. You can use either a point entity or a block to mark the segments.

To divide an entity into segments and mark them using point entities
  1. Advanced experience level
  2. Do one of the following:
  3. Choose Draw > Point > Divide.
  4. Type divide and then press Enter.
  5. Select the entity.
  6. Specify the number of segments, and then press Enter.
  7.  
     

    When you select the entity by pointing, divisions are marked beginning from the end closest to the point at which you select the entity ( A ). Blocks or point entities ( B ) are placed along the entity to mark it in equal intervals.

To divide an entity into segments and mark them using blocks
  1. Advanced experience level
  2. Do one of the following:
  3. Choose Draw > Point > Divide.
  4. Type divide and then press Enter.
  5. Select the entity.
  6. In the prompt box, choose Insert Blocks.
  7. Type the name of the block you want to insert as the marker.
  8. In the prompt box, choose either Yes-Align Blocks to rotate each insertion of the block so that its vertical alignment is always perpendicular to the entity or No-Do Not Align to insert each copy of the block with a zero rotation angle.
  9. Specify the number of segments, and then press Enter.