progeCAD Professional manual The low-cost alternative to AutoCAD

Index



Do you want to try progeCAD Professional?
Download the trial: you can try the product, without any limit, for 30 days!

A manual page a day... Click here to see the manual table of contents.

Getting drawing information - Specifying measurements and divisions

Specify the segment length, and then press Enter.

 

When you select the entity by pointing, intervals are measured from the end closest to the point at which you select the entity ( A ). Blocks or point entities ( B ) are placed along the entity at the specified interval.

To measure intervals along an entity and mark them using blocks
  1. Advanced experience level
  2. Do one of the following:
  3. Choose Draw > Point > Measure.
  4. Type measure and then press Enter.
  5. Select the entity.
  6. In the prompt box, choose Insert Blocks.
  7. Type the name of the block you want to insert as the marker.
  8. In the prompt box, choose either Yes-Align Blocks to rotate each insertion of the block so that its vertical alignment is always perpendicular to the entity or No-Do Not Align to insert each copy of the block with a zero rotation angle.